713 LAGGING ADHESIVE AND COATING | |||
|
713 is a high-quality, fire-resistant lagging adhesive and coating to be used over moderate temperature insulation systems. 713 has a full bodied consistency which minimizes sagging and dripping during application and has excellent brushability. 713 is normally used in conjunction with lagging cloth to secure and seal pipe insulation (or similar types of insulation). When dry, it provides a tight moisture resistant bond between cloth and insulation, and a surface which is resistant to mild alkalies, asphalts, acids and salts. 713 CONTAINS NO ASBESTOS, LEAD, MERCURY OR MERCURY COMPOUNDS. 713 may be applied by brush, spray or roller; when cured, it presents a washable and repaintable surface. Palm grade is available upon request. 713, until thoroughly cured, must be protected during and after application from: precipitation, freezing, oil, grease and foot traffic
CAUTION:
Do not thin. U.S. Coast Guard Approved No. 164.012/74/0
COMPLIES WITH 713 Nuclear Grade is available to comply with NRC Reg. Guide 1.36 or MIL-I-24244C(SH). This data sheet is not intended to represent exact data for 713 Nuclear Grade. NOTE: TEST REPORTS SHOWING SPECIFICATION COMPLIANCE ARE AVAILABLE ON EACH PRODUCTION BATCH OF 713. |
COLOR White-Grade A; Red-Grade B COVERAGE (ASTM C 461) 43 sq. ft./gal @ .015 inch dry (1.3 m² /liter @ .38 mm) DRYING TIME (ASTM D 1640-69) To touch: 2 hours Through: 12 to 48 hours (Depending upon temperature and relative humidity) WEIGHT PER U.S. GALLON (ASTM D 1475-60) 10.8 pounds (1.31 kg./liter) SOLIDS 54% by weight 40% + 2% by volume SERVICE TEMPERATURE RANGE 20ºF (-7ºC) to 180ºF (82ºC) APPLICATION TEMPERATURE RANGE 40ºF (4ºC) to 120ºF (49ºC) CLEANUP Wet state: water Dry state: safety solvent RECOMMENDED SHELF LIFE 18 months in unopened container @ 40ºF (4ºC) to 90ºF (32ºC) WET FLAMMABILITY INFORMATION No flash to boiling (212ºF) closed cup (ASTM D 93) FLAME SPREAD INDEX (ASTM E 162) 17 @ .035 inch dry (18.3 sq. ft./gal.)
| ||
